Fitting instructions are available for viewing in Acrobat Reader.
Additional points to observe when fitting the VORTEX unit
1. The VORTEX muffler must replace the vehicle’s existing main muffler.
2. Higher revs may be experienced after fitment of the VORTEX. In this event disconnect the battery for a short period and then reconnect it to power down the engine management software in your car. Alternatively drive your vehicle for 30–60 miles (50 to 100 miles) and normally the engine management software will re-adjust the tuning to accommodate the VORTEX exhaust system.
3. Vehicles that have been equipped with non-learning mappable ECU’s will require a software upgrade to recognise changes introduced by the VORTEX muffler. Alternatively, the mappable ECU may be replaced with a learnable ECU.
Warranty
Our Vortex Exhaust Resonators have a warranty of 3-years from time of fitting. This covers the customer for any product defect or failure any time during the warranty period. In the case of failure we will replace the Vortex Exhaust Resonator free of charge and the replacement would be covered for the remainder of the warranty period. We would not accept warranty claims in the case of:
Damage by contaminants caused by an engine running outside of normal specifications or with a faulty turbocharger. Damage caused by mishandling or accidents.
